Z800 Multi-3D Almost Ready to Ship
We have been working on a complete overhaul of the eMagin Z800's electronics. The main reason for this modification was to support dual input 3D. While we were at it, we added independent Gain and Offset adjustment as well as luminance control for each display to maintain image balance over the life of the product.
The new electronics support:
i) Single Input 2D
ii) Single Input 3D - Frame Sequential
iii) Dual Input 3D
If you have a dual output ATI video card, you should be able to see 3D on the Z800 now!
Retrofits should be quite simple and takes just a few minutes: just replace the PCB in the Z800 visor and the PCB in the interface module and you are done. We utilize the existing cabling and earbuds.
The tracker is NOT supported in this version as we have been unable to get any technical support from the manufacturer to include it in this revision.
The electronics are in final testing right now and should be available by Mid-September.
The new electronics support:
i) Single Input 2D
ii) Single Input 3D - Frame Sequential
iii) Dual Input 3D
If you have a dual output ATI video card, you should be able to see 3D on the Z800 now!
Retrofits should be quite simple and takes just a few minutes: just replace the PCB in the Z800 visor and the PCB in the interface module and you are done. We utilize the existing cabling and earbuds.
The tracker is NOT supported in this version as we have been unable to get any technical support from the manufacturer to include it in this revision.
The electronics are in final testing right now and should be available by Mid-September.
posted by Admin at
11:15 AM
0 Comments:
Post a Comment
<< Home